HP VPN Firewall Appliances Network Management Configuration Guide

143
Ste
p
Command Remarks
2. Create a VLAN for the
firewall card and enter
VLAN view.
vlan vlan-id N/A
3. Exit to system view.
quit N/A
4. Enter the view of the
ten-GigabitEthernet
interface that connects to the
switch.
interface ten-gigabitethernet
interface-number
N/A
5. Configure the operating
mode of the interface as
Layer 2.
port link-mode bridge
The default operating mode
depends on the device model.
6. Configure the link type of the
ten-GigabitEthernet
interface as trunk.
port link-type trunk N/A
7. Assign the trunk port to the
specified VLANs.
port trunk permit vlan { vlan-id-list
| all }
The VLAN of the firewall card and
the VLANs where the subinterfaces
of the ten-GigabitEthernet interface
reside must be included.
8. Create a subinterface of the
ten-GigabitEthernet
interface and enter
subinterface view.
interface ten-gigabitethernet
interface-number.subnumber
The subnumber must be one of the
VLAN IDs created on the switch.
9. Configure the operating
mode of the subinterface as
Layer 2.
port link-mode bridge
The default operating mode
depends on the device model.
10. Configure the link type of the
subinterface as access.
port link-type access
Optional.
By default, the link type of a
subinterface is access.
11. Assign the subinterface to
the VLAN of the firewall
card.
port access vlan vlan-id N/A
12. Create another subinterface
and enter subinterface view.
interface ten-gigabitethernet
interface-number.subnumber
The subnumber must be the ID of the
other VLAN created on the switch.
13. Configure the operating
mode of the subinterface as
Layer 2.
port link-mode bridge
The default operating mode
depends on the device model.
14. Configure the link type of the
subinterface as access.
port link-type access
Optional.
By default, the link type of a
subinterface is access.
15. Assign the subinterface to
the VLAN of the firewall
card.
port access vlan vlan-id N/A