HP VPN Firewall Appliances Network Management Configuration Guide

4
Creating an interface
1. Select Device Management > Interface from the navigation tree.
2. Click Add to enter the page for creating an interface.
Figure 3 Creating an interface
3. Configure the interface information as described in Table 1.
4. Click Apply.
Table 1 Configuration items
Item Descri
p
tion
Interface Name
Set the name for the interface or its subinterface.
• If you select a logical interface type from the list, such as Dialer,
LoopBack, Tunnel, Vlan-interface, Virtual-Template,
Route-Aggregation, or Bridge-Aggregation, set the interface number in
the box behind to create the logical interface.
• If you select a specific Ethernet interface name from the list, such as
GigabitEthernet 0/1, set the subinterface number in the box behind to
create a subinterface of the Ethernet interface.
• If you select a specific RAGG interface name from the list, such as
Route-Aggregation, set the subinterface number in the box behind to
create a subinterface of the RAGG interface.