HP VPN Firewall Appliances Network Management Configuration Guide

259
Ste
p
Command Remarks
3. Enable local proxy ARP.
local-proxy-arp enable [ ip-range startIP to endIP ] Disabled by default.
Displaying and maintaining proxy ARP
Task Command Remarks
Display whether proxy
ARP is enabled.
display proxy-arp [ interface interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display whether local
proxy ARP is enabled.
display local-proxy-arp [ interface interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Proxy ARP configuration examples
Common proxy ARP configuration example
Network requirements
Host A and Host D have the same prefix and mask, but they are located on different subnets. No default
gateway is configured on Host A and Host D.
Configure proxy ARP on the firewall to enable communication between Host A and Host D.
Figure 173 Network diagram
Configuration procedure
# Configure the IP address of interface GigabitEthernet 0/2.
<Firewall> system-view