HP VPN Firewall Appliances Network Management Configuration Guide

318
4. Click Apply.
Table 39 Configuration items
Item Descri
p
tion
CAR List Index Specify the CAR list index.
IP Type Configure a source IP-based CAR list or destination IP-based CAR list.
IP Set
Define the way of specifying a set of IP addresses. Two options are available:
• Subnet—Specifies a network segment by specifying an IP address and a
subnet mask.
• IP Range—Specifies an IP address range by specifying a start IP address
and an end IP address.
IP Address
Specify an IP address and a subnet mask.
The two items are available when you select Subnet from the IP Set list.
Mask
Start IP Address
Specify a start IP address and an end IP address.
The two items are available when you select IP Range from the IP Set list.
End IP Address
Limit Rate Per IP Address
Specify to perform per-IP address rate limiting.
With this function enabled, rate limiting is performed for traffic of each IP
address in the specified IP address set separately. Otherwise, rate limiting is
performed for all traffic of the IP address set.
Shared Bandwidth
Specify that the traffic of all IP addresses in the specified IP address set shares
the remaining bandwidth.
This item is available when you select Enable from the Limit Rate Per IP Address
list.
Applying a CAR list to an interface
1. Select Firewall > Traffic Policing > Apply from the navigation tree to enter the page for displaying
the CAR lists applied to interfaces.
Figure 231 CAR lists applied to interfaces
2. Click Apply Policy to enter the page for applying a CAR list to an interface.