HP VPN Firewall Appliances Network Management Configuration Guide

320
Item Descri
p
tion
EBS Set the EBS.
Green
Set the action to be taken on conforming packets:
• Discard—Drops the packets.
• Pass—Permits the packets to pass through.
Red
Set the action to be taken on excess packets:
• Discard—Drops the packets.
• Pass—Permits the packets to pass through.
Traffic policing configuration example
Network requirements
As shown in Figure 233, configure the firewall to limit the total rate of traffic received on GigabitEthernet
0/1 to 50 kbps.
Figure 233 Network diagram
Configuring the firewall
1. Configure a CAR list:
a. Select Firewall > Traffic Policing > CAR List from the navigation tree.
b. Click Add.
c. Enter 1 as the CAR list index.
d. Select Source IP from the IP Type list.
e. Select IP Range from the IP Set list.
f. Enter 2.1.1.1 as the start IP address.
g. Enter 2.1.1.100 as the end IP address.
h. Select Enable from the Limit Rate Per IP Address list.
i. Select Enable from the Share Bandwidth list.
j. Click Apply.