Manualshelf

HP VPN Firewall Appliances Network Management Configuration Guide

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve Switch xl Access Controller Module
351352353354355356357358359360
334
c. Enter 0.0.0.0 as the destination IP address, select 0.0.0.0 from the mask list, and enter 1.1.4.2
as the next hop.
d. Click Apply.
Figure 240 Configuring a static route on Device A
4. Configure a static route to Device A and a static route to Device C on Device B:
a. Select Network > Routing Management > Static Routing from the navigation tree.
b. Click Add.
c. Enter 1.1.2.0 as the destination IP address, select 255.255.255.0 from the mask list, and enter
1.1.4.1 as the next hop.
d. Click Apply.
e. Click Add.
f. Enter 1.1.3.0 as the destination IP address, select 255.255.255.0 from the mask list, and enter
1.1.5.6 as the next hop.
g. Click Apply.
5. Configure a static route to Device B on Device C:
a. Select Network > Routing Management > Static Routing from the navigation tree.
b. Click Add.
c. Enter 0.0.0.0 as the destination IP address, select 0.0.0.0 from the mask list, and enter 1.1.5.5
as the next hop.
d. Click Apply.
Verifying the configuration
1. Ping Host A on Host B (suppose the host runs Windows XP):
C:\Documents and Settings\Administrator>ping 1.1.2.2
Pinging 1.1.2.2 with 32 bytes of data:
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128
Reply from 1.1.2.2: bytes=32 time=1ms TTL=128