HP VPN Firewall Appliances Network Management Configuration Guide

352
Configuring Device B
1. Configure IP addresses for interfaces and add interfaces to the security zones. (Details not shown)
2. Enable RIP:
a. Select Network > Routing Management > RIP from the navigation tree.
b. Select the Enable RIP(Enable all interfaces automatically) box.
c. Click Apply.
Verifying the configuration
1. Display active routes of Device A:
Select Network > Routing Management > Routing Info from the navigation tree to display learned
RIP route destined for 10.0.0.0/8.
Figure 249 RIP configuration result I
2. Display active routes of Device B:
Select Network > Routing Management > Routing Info from the navigation tree to display learned
RIP routes destined for 2.0.0.0/8 and 3.0.0.0/8.
Figure 250 RIP configuration result II