HP VPN Firewall Appliances Network Management Configuration Guide

353
Configuring RIP at the CLI
RIP configuration task list
Task Remarks
Configuring basic RIP Required
Configuring
RIP route
control
Configuring an additional routing metric Optional
Configuring RIPv2 route summarization Optional
Disabling host route reception Optional
Advertising a default route Optional
Configuring received/redistributed route filteringConfiguring
received/redistributed route filteringConfiguring received/redistributed route
filtering
Optional
Configuring a preference for RIP Optional
Configuring RIP route redistribution Optional
Tuning and
optimizing
RIP
networks
Configuring RIP timers Optional
Configuring split horizon and poison reverse Optional
Configuring the maximum number of ECMP routes Optional
Enabling zero field check on incoming RIPv1 messages Optional
Enabling source IP address check on incoming RIP updates Optional
Configuring RIPv2 message authentication Optional
Specifying a RIP neighbor Optional
Configuring RIP-to-MIB binding Optional
Configuring the RIP packet sending rate Optional
Configuring
BFD for RIP
Configuring single-hop echo detection (for a directly connected RIP neighbor) Optional
Configuring single-hop echo detection (for a specific destination) Optional
Configuring bidirectional control detection Optional
Configuring basic RIP
Before you configure basic RIP settings, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
Enabling RIP
Perform this task to create a RIP process and enable the RIP process on the interface attached to the
specified network. An interface that is not on the specified network does not run RIP.