HP VPN Firewall Appliances Network Management Configuration Guide
355
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify a global RIP
version.
version { 1 | 2 }
Optional.
By default, if an interface has an
interface-specific RIP version, the version
takes precedence over the global one. If no
interface-specific RIP version is specified, the
interface can send RIPv1 broadcasts, and
receive RIPv1 broadcasts and unicasts, and
RIPv2 broadcasts, multicasts, and unicasts.
4. Return to system view.
quit N/A
5. Enter interface view.
interface interface-type
interface-number
N/A
6. Specify a RIP version
for the interface.
rip version { 1 | 2 [ broadcast |
multicast ] }
Optional.
By default, if an interface has no RIP version
specified, the global version takes effect. If
no global RIP version is specified, the
interface can send RIPv1 broadcasts, and
receive RIPv1 broadcasts and unicasts, and
RIPv2 broadcasts, multicasts, and unicasts.
Configuring RIP route control
Before you configure RIP routing feature, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
• Configure basic RIP.
Configuring an additional routing metric
An additional routing metric (hop count) can be added to the metric of an inbound or outbound RIP
route.
An outbound additional metric is added to the metric of a sent route, and it does not change the route's
metric in the routing table.
An inbound additional metric is added to the metric of a received route before the route is added into the
routing table, and the route's metric is changed. If the sum of the additional metric and the original metric
is greater than 16, the metric of the route becomes 16.
To configure additional routing metrics:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify an inbound
additional routing metric.
rip metricin [ route-policy
route-policy-name ] value
Optional.
The default setting is 0.