HP VPN Firewall Appliances Network Management Configuration Guide
358
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure the
filtering of received
routes.
filter-policy { acl-number |
gateway ip-prefix-name |
ip-prefix ip-prefix-name [ gateway
ip-prefix-name ] } import
[ interface-type interface-number ]
By default, the filtering of received routes is
not configured.
The filter-policy import command filters
received routes. Filtered routes are not
installed into the routing table or advertised
to neighbors.
4. Configure the
filtering of
redistributed routes.
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ protocol [ process-id ] |
interface-type interface-number ]
By default, the filtering of redistributed routes
is not configured.
The filter-policy export command filters
redistributed routes, including routes
redistributed with the import-route
command.
Configuring a preference for RIP
If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest priority
is selected as the optimal route. Perform this task to configure a preference for RIP. The smaller the
preference value, the higher the priority.
To configure a preference for RIP:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a preference for
RIP.
preference [ route-policy
route-policy-name ] value
Optional.
The default setting is 100.
Configuring RIP route redistribution
Perform this task to configure RIP to redistribute routes from other routing protocols, including OSPF, IS-IS,
BGP, static, and direct routes. Only active routes can be redistributed. To display active routes, use the
display ip routing-table protocol command.
To configure RIP route redistribution:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a default metric for
redistributed routes.
default cost value
Optional.
The default setting is 0.