HP VPN Firewall Appliances Network Management Configuration Guide

386
Configuring Device C
1. Configure IP addresses for interfaces and add interfaces to the security zones. (Details not shown.)
2. Enable OSPF, and configure OSPF to redistribute static routes:
a. Select Network > Routing Management > OSPF from the navigation tree of Device C.
b. Select the Enable OSPF and the Import static routes boxes.
c. Click Apply.
3. Configure NSSA area Area 1:
a. Click Add on the Area Configuration tab.
b. Enter 1 for Area ID, select NSSA for Area Type, enter 10.2.1.0 for Network Address, select
0.0.0.255 for Network Mask, and click Add Network.
c. Enter 10.4.1.0 for Network Address, select 0.0.0.255 for Network Mask, and click Add
Network.
d. Click Apply.
4. Configure static routes:
a. Select Network > Routing Management > Static Routing from the navigation tree.
b. Click Add.
The static route configuration page appears.
c. Enter 3.
2.1.1 as the destination IP address, select 255.255.255.
0 from the mask list, and enter
10.4.1.2 as the next hop.
d. Click Apply.
Figure 267 Adding a static route
Configuring Device D
1. Configure IP addresses for interfaces and add interfaces to the security zones. (Details not shown.)
2. Enable OSPF:
a. Select Network > Routing Management > OSPF from the navigation tree of Device D.
b. Select the Enable OSPF box.
c. Click Apply.
3. Configure Normal area Area 2:
a. Click Add on the Area Configuration tab.