HP VPN Firewall Appliances Network Management Configuration Guide

388
Complete the following tasks to configure OSPF:
Task Remarks
Enabling OSPF Required
Configuring OSPF
areas
Configuring a stub area
Optional
Configuring an NSSA area
Configuring a virtual link
Configuring OSPF
network types
Configuring the broadcast network type for an interface Optional
Configuring the NBMA network type for an interface Optional
Configuring the P2MP network type for an interface Optional
Configuring the P2P network type for an interface Optional
Configuring OSPF
route control
Configuring OSPF route summarization Optional
Configuring OSPF inbound route filtering Optional
Configuring ABR Type-3 LSA filtering Optional
Configuring an OSPF cost for an interface Optional
Configuring the maximum number of ECMP routes Optional
Configuring OSPF preference Optional
Configuring OSPF route redistribution Optional
Advertising a host route Optional
Tuning and
optimizing OSPF
networks
Configuring OSPF packet timers Optional
Specifying LSA transmission delay Optional
Specifying SPF calculation interval Optional
Specifying the LSA arrival interval Optional
Specifying the LSA generation interval Optional
Disabling interfaces from receiving and sending OSPF packets Optional
Configuring stub routers Optional
Configuring OSPF authentication Optional
Adding the interface MTU into DD packets Optional
Configuring the maximum number of external LSAs in LSDB Optional
Enabling compatibility with RFC 1583 Optional
Logging neighbor state changes Optional
Configuring OSPF network management Optional
Enabling message logging Optional
Enabling the advertisement and reception of opaque LSAs Optional
Configuring OSPF to give priority to receiving and processing hello
packets
Optional
Configuring the LSU transmit rate Optional
Enabling OSPF ISPF Optional