HP VPN Firewall Appliances Network Management Configuration Guide
401
When network changes are not frequent, the minimum-interval is adopted. If network changes become
frequent, the SPF calculation interval is incremented by incremental-interval × 2
n-2
(n is the number of
calculation times) each time a calculation occurs until the maximum-interval is reached.
To configure SPF calculation interval:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Specify the SPF
calculation interval.
spf-schedule-interval maximum-interval
[ minimum-interval [ incremental-interval ] ]
Optional.
By default, the interval is 5 seconds.
Specifying the LSA arrival interval
If OSPF receives an LSA that has the same LSA type, LS ID, and router ID as the previously received LSA
within the LSA arrival interval, OSPF discards the LSA to save bandwidth and route resources.
To configure the LSA arrival interval:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
3. Configure the LSA
arrival interval.
lsa-arrival-interval interval
Optional.
The default interval is 1000 milliseconds.
Make sure this interval is smaller than or equal
to the interval set with the
lsa-generation-interval command.
Specifying the LSA generation interval
You can adjust the LSA generation interval to protect network resources and routers from being over
consumed by frequent network changes.
When network changes are not frequent, LSAs are generated at the minimum-interval. If network
changes become frequent, the LSA generation interval is incremented by incremental-interval × 2
n-2
(n is
the number of generation times) each time a LSA generation occurs until the maximum-interval is
reached.
To configure the LSA generation interval:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A