HP VPN Firewall Appliances Network Management Configuration Guide

462

Interface information for ISIS(1)

---------------------------------

Interface: Ethernet1/1

Id IPV4.State IPV6.State MTU Type DIS

001 Up Down 1497 L1/L2 No/No

IS-IS route redistribution configuration example

Network requirements

As shown in Figure 282, Router A, Router B, Router C, and Firewall reside in the same AS. They use IS-IS

to interconnect. Router A and Router B are Level-1 routers, Firewall is a Level-2 router, and Router C is a

Level-1-2 router.

Redistribute RIP routes into IS-IS on Firewall.

Figure 282 Network diagram

Configuration procedure

1. Configure IP addresses for interfaces. (Details not shown.)

2. Configure basic IS-IS:

# Configure Router A.

<RouterA> system-view

[RouterA] isis 1

[RouterA-isis-1] is-level level-1

[RouterA-isis-1] network-entity 10.0000.0000.0001.00

[RouterA-isis-1] quit

[RouterA] interface gigabitethernet 1/1

[RouterA-GigabitEthernet1/1] isis enable 1

[RouterA-GigabitEthernet1/1] quit

# Configure Router B.

<RouterB> system-view

[RouterB] isis 1

[RouterB-isis-1] is-level level-1

[RouterB-isis-1] network-entity 10.0000.0000.0002.00

[RouterB-isis-1] quit