HP VPN Firewall Appliances Network Management Configuration Guide

480
Ste
p
Command Remarks
7. Configure a description for
a peer group.
peer group-name description
description-text
Optional.
By default, no description is
configured for the peer group.
To configure an EBGP peer group by using Method 2:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family
vpn-instance
vpn-instance-name
Use either method.
3. Create an EBGP peer group
group group-name external N/A
4. Create a BGP peer and
specify its AS number.
peer ip-address as-number
as-number
N/A
5. Add a peer into the EBGP
peer group.
peer ip-address group
group-name [ as-number
as-number ]
The as-number as-number
option, if used, must specify the
same AS number as the peer
ip-address as-number as-number
command.
6. Enable the default use of
IPv4 unicast address family
for the peers that are
established using the peer
as-number command.
default ipv4-unicast
Optional.
Enabled by default.
This command is not supported in
BGP-VPN instance view.
7. Enable a peer.
peer ip-address enable
Optional.
Enabled by default.
8. Configure a description for
a peer group.
peer group-name description
description-text
Optional.
By default, no description is
configured for the peer group.
To configure an EBGP peer group by using Method 3:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family
vpn-instance
vpn-instance-name
Use either method.