Manualshelf

HP VPN Firewall Appliances Network Management Configuration Guide

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve Switch xl Access Controller Module
511512513514515516517518519520
497
Ste
p
Command
Remarks
2. Enter BGP view or
BGP-VPN instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family vpn-instance
vpn-instance-name
Use either method.
3. Configure BGP
keepalive interval and
holdtime.
• Configure the global keepalive interval
and holdtime:
timer keepalive keepalive hold holdtime
• Configure the keepalive interval and
holdtime for a peer or peer group:
peer { group-name | ip-address } timer
keepalive keepalive hold holdtime
Optional.
By default, the keepalive
interval is 60 seconds, and
holdtime is 180 seconds.
Configuring the interval for sending the same update
A BGP router sends an update message to its peers when a route is changed. If the route changes
frequently, the BGP router sends a large number of updates for the route, which can cause route flaps.
This task allows you to configure the interval for sending the same update to a peer or peer group,
avoiding frequent update sending and route flaps.
To configure the interval for sending the same update to a peer or peer group:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or
BGP-VPN instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ipv4-family vpn-instance
vpn-instance-name
Use either method.
3. Configure the interval for
sending the same
update to a peer or peer
group.
peer { group-name | ip-address }
route-update-interval interval
Optional.
By default, the intervals for sending
the same update to an IBGP peer
and an EBGP peer are 15 seconds
and 30 seconds, respectively.
Allowing establishment of EBGP session to an indirectly connected peer or peer group
Direct physical links must be available between EBGP peers. If not, use the peer ebgp-max-hop
command to establish an EBGP session over multiple hops between two peers.
To allow establishment of EBGP session to an indirectly connected peer or peer group:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A