HP VPN Firewall Appliances Network Management Configuration Guide

534
[FirewallB] interface gigabitethernet 1/1
[FirewallB-GigabitEthernet1/1] bfd min-transmit-interval 500
[FirewallB-GigabitEthernet1/1] bfd min-receive-interval 500
[FirewallB-GigabitEthernet1/1] bfd detect-multiplier 7
[FirewallB-GigabitEthernet1/1] bfd authentication-mode simple 1 ibgpbfd
[FirewallB-GigabitEthernet1/1] return
7. Verify the configuration:
# Display detailed BFD session information on Firewall B.
<FirewallB> display bfd session verbose
Total Session Num: 1 Init Mode: Active
IP Session Working Under Ctrl Mode:
Local Discr: 17 Remote Discr: 13
Source IP: 3.0.2.2 Destination IP: 3.0.1.1
Session State: Up Interface: GigabitEthernet1/1
Min Trans Inter: 500ms Act Trans Inter: 500ms
Min Recv Inter: 500ms Act Detect Inter: 3500ms
Recv Pkt Num: 57 Send Pkt Num: 53
Hold Time: 2200ms Connect Type: Indirect
Running Up for: 00:00:06 Auth mode: Simple
Protocol: BGP
Diag Info: No Diagnostic
The output shows that a BFD session is established between GigabitEthernet 1/2 of Firewall A and
GigabitEthernet 1/1 of Firewall B and that BFD runs.
# Display BGP peer information on Firewall B.
<FirewallB> display bgp peer
BGP local router ID : 1.1.1.1
Local AS number : 200
Total number of peers : 2 Peers in established state : 2
Peer AS MsgRcvd MsgSent OutQ PrefRcv Up/Down State
2.0.1.1 200 7 10 0 0 00:01:05 Established
3.0.1.1 200 7 10 0 0 00:01:34 Established
The output shows that Firewall B has established two BGP connections with Firewall A, and both
connections are in Established state.
# Display route 1.1.1.0/24 on Firewall B.
<FirewallB> display ip routing-table 1.1.1.0 24 verbose
Routing Table : Public
Summary Count : 4
Destination: 1.1.1.0/24
Protocol: BGP Process ID: 0
Preference: 140 Cost: 50