HP VPN Firewall Appliances Network Management Configuration Guide

35
Actions Access Trunk H
y
brid
Incoming
tagged frame
• Receives the frame if
its VLAN ID is the
same as the PVID.
• Drops the frame if its
VLAN ID is different
from the PVID.
• Receives the frame if its VLAN is permitted on the port.
• Drops the frame if its VLAN is not permitted on the port.
Outgoing
frames
Removes the VLAN tag
and sends the frame.
• Removes the tag and sends
the frame if the frame carries
the PVID tag and the port
belongs to the PVID.
• Sends the frame without
removing the tag if its VLAN
is carried on the port but is
different from the PVID.
Sends the frame if its VLAN is
permitted on the port. The frame
is sent with the VLAN tag
removed or intact depending on
your configuration with the port
hybrid vlan command. This is
true of the PVID.
Protocols and standards
IEEE 802.1Q, IEEE Standards for Local and Metropolitan Area Networks: Virtual Bridged Local Area
Networks
Configuring VLANs in the Web interface
Recommended VLAN configuration procedure
Ste
p
Remarks
1. Creating a VLAN.
Required.
As the default VLAN, VLAN 1 cannot be created or removed. You cannot
manually create or remove VLANs reserved for special purposes.
2. Modifying a VLAN.
Required.
Select either task.
Configure the untagged member ports and tagged member ports of the VLAN,
or remove ports from the VLAN.
3. Modifying a port.
Creating a VLAN
1. Select Network > VLAN > VLAN from the navigation tree.
The page as shown in Figure 17 appears.