HP VPN Firewall Appliances Network Management Configuration Guide

572
[Firewall-ospf-1-area-0.0.0.0] quit
[Firewall-ospf-1] quit
d. Enable IP multicast routing, PIM-DM, and IGMP:
# Enable multicast routing on Router A and enable PIM-DM on each interface.
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim dm
[RouterA-Ethernet1/2] quit
[RouterA] interface tunnel 0
[RouterA-Tunnel0] pim dm
[RouterA-Tunnel0] quit
# Enable multicast routing on the firewall, enable PIM-DM on each interface, and enable IGMP
on GigabitEthernet 0/1.
[Firewall] multicast routing-enable
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] igmp enable
[Firewall-GigabitEthernet0/1] pim dm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/2
[Firewall-GigabitEthernet0/2] pim dm
[Firewall-GigabitEthernet0/2] quit
[Firewall] interface tunnel 0
[Firewall-Tunnel0] pim dm
[Firewall-Tunnel0] quit
e. On the firewall, configure a static multicast route and specify its RPF neighbor leading toward
Source is Tunnel 0 on Router A.
[Firewall] ip rpf-route-static 10.1.1.0 24 50.1.1.1
f. Verifying the configuration
The source sends multicast data to the multicast group 225.1.1.1 and the receiver can receive
the multicast data after joining the multicast group. You can display PIM routing table
information on the routers using the display pim routing-table command. For example:
# Display PIM routing table information on the firewall.
[Firewall] display pim routing-table
VPN-Instance: public net
Total 1 (*, G) entry; 1 (S, G) entry
(*, 225.1.1.1)
Protocol: pim-dm, Flag: WC
UpTime: 00:04:25
Upstream interface: NULL
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1