HP VPN Firewall Appliances Network Management Configuration Guide

574
Multicast data fails to reach receivers
Symptom
The multicast data can reach some routers but fails to reach the last-hop router.
Analysis
If you have configured a multicast forwarding boundary by using the multicast boundary command, any
multicast packet will be kept from crossing the boundary.
Solution
1. Use the display pim routing-table command to verify that the corresponding (S, G) entries exist on
the router. If so, the router has received the multicast data. Otherwise, the router has not received
the data.
2. Use the display multicast boundary command to view the multicast boundary information on the
interfaces. Use the multicast boundary command to change the multicast forwarding boundary
setting.
3. In PIM-SM, use the display current-configuration command to check the BSR and RP information.