HP VPN Firewall Appliances Network Management Configuration Guide

578
Figure 332 Network diagram
Configuring IP addresses and unicast routing
This example assumes that the IP addresses of the interfaces and the security zone have been configured
according to the network diagram, and that the OSPF protocol is configured to ensure the network-layer
interoperation on the PIM network and dynamic update of routing information among the devices
through a unicast routing protocol.
Configuring Device A
1. Enable multicast routing:
a. From the navigation tree, select Network > Routing Management > Multicast Routing.
b. Select Enable from the list.
c. Click Apply.
Figure 333 Enabling IP multicast routing
2. Enable PIM-DM on all interfaces:
a. From the navigation tree, select Network > Routing Management > PIM.
b. Click the icon for GigabitEthernet 0/1.
c. Select PIM-DM from the list.
d. Click Apply.
e. Click the icon for GigabitEthernet 0/2.
f. Select PIM-DM from the list.
g. Click Apply.
Device A
Device B
Device C
Querier
PIM network
N1
N2
Receiver
Receiver
Host A
Host B
Host C
Host D
GE0/1
10.110.1.1/24
GE0/1
10.110.2.1/24
GE0/1
10.110.2.2/24
GE0/2
GE0/2
GE0/2