HP VPN Firewall Appliances Network Management Configuration Guide

604
Figure 344 Network diagram
Table 65 Interface and IP address assignment
Device Interface
IP address
Device A GigabitEthernet 0/1 192.168.2.1/24
Device A GigabitEthernet 0/3 10.1.1.2/24
Device B GigabitEthernet 0/1 192.168.3.1/24
Device B GigabitEthernet 0/3 10.1.2.2/24
Device C GigabitEthernet 0/1 10.1.1.1/24
Device C GigabitEthernet 0/2 10.1.2.1/24
Device C GigabitEthernet 0/3 192.168.1.1/24
This example assumes that the IP address has been configured for each interface according to the
network diagram, the security zone is configured, and OSPF has been enabled on the devices in the
PIM-DM domain to ensure the network-layer interoperation in the PIM-DM domain and enable dynamic
update of routing information through a unicast routing protocol.
Configuring Device A
1. Enable IP multicast routing:
a. From the navigation tree, select Network > Routing Management > Multicast Routing.
b. Select Enable from the list.
c. Click Apply.
Figure 345 Enabling IP multicast routing
Ethernet
Ethernet
Source
192.168.1.16/24
PIM-DM
Device A
Device B
Device C
Receiver
Host A
Host B
N1
GE0/1
192.168.2.1/24
GE0/1
192.168.3.1/24
GE0/3
192.168.1.1/24
GE0/2
10.1.2.1/24
GE0/1
10.1.1.1/24
Ethernet
Receiver
Host C
Host D
N2
GE0/3
10.1.2.2/24
GE0/3
10.1.1.2/24