HP VPN Firewall Appliances Network Management Configuration Guide

606
c. Specify the operating mode as PIM-DM.
d. Click Apply.
e. Click the icon for GigabitEthernet 0/1.
f. Specify the operating mode as PIM-DM.
g. Click Apply.
h. Click the icon corresponding to GigabitEthernet 0/2.
i. Specify the operating mode as PIM-DM.
j. Click Apply.
Verifying the configuration
To display PIM neighbor information on Device C:
1. From the navigation tree, select Network > Routing Management > PIM.
2. Click the Neighbor Information tab.
Figure 348 PIM neighbor information
Configuring PIM at the CLI
Configuring PIM-DM at the CLI
This section describes how to configure PIM-DM.
PIM-DM configuration task list
Task Remarks
Enabling PIM-DM Required.
Enabling state-refresh capability Optional.
Configuring state-refresh parameters Optional.
Configuring PIM-DM graft retry period Optional.
Configuring common PIM features at the CLI Optional.
Configuration prerequisites
Before you configure PIM-DM, complete the following tasks: