HP VPN Firewall Appliances Network Management Configuration Guide

627
PIM configuration examples
This section provides examples of configuring PIM on routers.
PIM-DM configuration example
1. Network requirements
As shown in Figure 344, the receivers receive VOD information through multicas
t. The receiver
groups of different organizations form stub networks, and one or more receiver hosts exist in each
stub network. The entire PIM domain is operating in the dense mode.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
IGMPv2 runs between Router A and N1, and between Router B, Router C, and N2.
Figure 349 Network diagram
Table 66 Interface and IP address assignment
Device Interface
IP address
Router A Ethernet 1/1 10.110.1.1/24
Router A Ethernet 1/2 192.168.1.1/24
Router B Ethernet 1/1 10.110.2.1/24
Router B Ethernet 1/2 192.168.2.1/24
Router C Ethernet 1/1 10.110.2.2/24
Router C Ethernet 1/2 192.168.3.1/24
Firewall GigabitEthernet 0/1 10.110.5.1/24
Firewall GigabitEthernet 0/2 192.168.1.2/24
Firewall GigabitEthernet 0/3 192.168.2.2/24
Source
10.110.5.100/24
PIM-DM
Router A
Router B
Router C
Firewall
Receiver
Host A
Host B
Host C
Host D
Receiver
Eth1/1
Eth1/1
Eth1/1
GE0/1 GE0/3 Eth1/2
Eth1/2
G
E0/4
GE0/2 Eth1/2