HP VPN Firewall Appliances Network Management Configuration Guide

632
[Firewall-pim] c-rp gigabitethernet 0/3 group-policy 2005
[Firewall-pim] quit
# On Router D, configure the service scope of RP advertisements, specify a C-BSR and a C-RP,
and set the hash mask length to 32 and the priority of the C-BSR to 20.
<RouterD> system-view
[RouterD] acl number 2005
[RouterD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[RouterD-acl-basic-2005] quit
[RouterD] pim
[RouterD-pim] c-bsr pos 5/2 32 20
[RouterD-pim] c-rp pos 5/2 group-policy 2005
[RouterD-pim] quit
e. Verifying the configuration
Use the display pim interface command to display PIM information on each interface. For
example:
# Display PIM information on Router A.
[RouterA] display pim interface
VPN-Instance: public net
Interface NbrCnt HelloInt DR-Pri DR-Address
Eth1/1 0 30 1 10.110.1.1 (local)
Eth1/2 1 30 1 192.168.1.2
Pos5/0 1 30 1 192.168.9.2
# Display information about the BSR and locally configured C-RP on Router A.
[RouterA] display pim bsr-info
VPN-Instance: public net
Elected BSR Address: 192.168.9.2
Priority: 20
Hash mask length: 32
State: Accept Preferred
Scope: Not scoped
Uptime: 00:40:40
Expires: 00:01:42
# Display information about the BSR and locally configured C-RP on the firewall.
[Firewall] display pim bsr-info
VPN-Instance: public net
Elected BSR Address: 192.168.9.2
Priority: 20
Hash mask length: 32
State: Accept Preferred
Scope: Not scoped
Uptime: 00:05:26
Expires: 00:01:45
Candidate BSR Address: 192.168.4.2
Priority: 10
Hash mask length: 32
State: Candidate
Scope: Not scoped