HP VPN Firewall Appliances Network Management Configuration Guide

642

Figure 352 Network diagram

Table 69 Interface and IP address assignment

Device Interface IP address

Device

Interface IP address

Firewall GE0/1 10.110.1.1/24 Router C Eth1/1 10.110.5.1/24

Firewall GE0/2 192.168.1.1/24 Router C Eth1/2 192.168.1.2/24

Firewall GE0/3 192.168.9.1/24 Router C POS5/0 192.168.4.2/24

Router A Eth1/1 10.110.2.1/24 Router D POS5/0 192.168.3.2/24

Router A POS5/0 192.168.2.1/24 Router D POS5/1 192.168.2.2/24

Router B Eth1/1 10.110.2.2/24 Router D Eth1/1 192.168.9.2/24

Router B POS5/0 192.168.3.1/24 Router D POS5/3 192.168.4.1/24

2. Configuration procedure

a. Assign an IP address and subnet mask to each interface according to Figure 352. (Details not

shown.)

b. Configure OSPF on the routers in the PIM-

SSM domain to make sure they are interoperable at

the network layer. (Details not shown.)

c. Enable IP multicast routing, IGMP and PIM-SM:

# On the firewall, enable IP multicast routing globally, enable IGMPv3 on GigabitEthernet 0/1,

and enable PIM-SM on each interface.

<Firewall> system-view

[Firewall] multicast routing-enable

[Firewall] interface gigabitethernet 0/1

[Firewall-GigabitEthernet0/1] igmp enable

Eth1