HP VPN Firewall Appliances Network Management Configuration Guide

647
Solution
1. Use the display ip routing-table command to verify that routes to the RP and the BSR are available
on each router and that a route between the RP and the BSR is available. Make sure each C-RP has
a unicast route to the BSR, the BSR has a unicast route to each C-RP, and all the routers in the entire
network have a unicast route to the RP.
2. PIM-SM needs the support of the RP and BSR. Use the display pim bsr-info command to verify that
the BSR information exists on each router, and then use the display pim rp-info command to verify
that the RP information is correct on each router.
3. Use the display pim neighbor command to verify that the normal PIM neighboring relationship
have been established among the routers.