HP VPN Firewall Appliances Network Management Configuration Guide

656

Configure Loopback 0 as the C-BSR and C-RP of the related PIM-SM domain on Router B, Router C, and

the firewall.

Set up MSDP peering relationships between the RPs of the PIM-SM domains to share multicast source

information among the PIM-SM domains.

Figure 353 Network diagram

Table 70 Interface and IP address assignment

Device Interface IP address

Device

Interface IP address

Router A Eth1/1 10.110.1.2/24 Router D Eth1/1 10.110.4.2/24

Router A Eth1/2 10.110.2.1/24 Router D Eth1/2 10.110.5.1/24

Router A Eth1/3 10.110.3.1/24 Firewall GE0/1 10.110.6.1/24

Router B Eth1/1 10.110.1.1/24 Firewall GE0/2 192.168.3.2/24

Router B POS5/0 192.168.1.1/24 Firewall Loop0 3.3.3.3/32

Router B Loop0 1.1.1.1/32 Router E Eth1/1 10.110.6.2/24

Router C Eth1/1 10.110.4.1/24 Router E Eth1/2 10.110.7.1/24

Router C Eth1/2 192.168.3.1/24 Source 1 — 10.110.2.100/24

Router C POS5/0 192.168.1.2/24 Source 2 — 10.110.5.100/24

Router C Loop0 2.2.2.2/32

Configuration procedure

1. Assign IP addresses and configure unicast routing:

a. Assign the IP address and subnet mask to each interface according to Figure 353. (Details no

shown.)

Eth1

Eth1/1

Eth

1/3

Eth

1/2

Eth1/