HP VPN Firewall Appliances Network Management Configuration Guide

47
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to configure
the trunk port to allow packets from the PVID to pass through.
Assigning a hybrid port to a VLAN
A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view. Before assigning
a hybrid port to a VLAN, create the VLAN first.
To assign a hybrid port to one or multiple VLANs:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view or port
group view.
• Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
Use one of the commands.
• The configuration made in Ethernet
interface view applies only to the port.
• The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
3. Configure the link type of
the ports as hybrid.
port link-type hybrid By default, all ports are access ports.
4. Assign the hybrid ports to
the specified VLANs.
port hybrid vlan vlan-list
{ tagged | untagged }
By default, a hybrid port allows only packets
of VLAN 1 to pass through untagged.
5. Configure the PVID of the
hybrid ports.
port hybrid pvid vlan
vlan-id
Optional.
By default, the PVID is VLAN 1.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
After you configure the PVID for a hybrid port, you must use the port hybrid vlan command to configure
the hybrid port to allow packets from the PVID to pass through.
Displaying and maintaining VLAN
Task Command Remarks
Display VLAN information.
display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic
| reserved | static ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.