HP VPN Firewall Appliances Network Management Configuration Guide

699
[FirewallA-GigabitEthernet0/2] undo ipv6 nd ra halt
[FirewallA-GigabitEthernet0/2] quit
2. Configure Firewall B:
# Enable IPv6.
<FirewallB> system-view
[FirewallB] ipv6
# Assign a global unicast address for interface GigabitEthernet 0/1.
[FirewallB] interface gigabitethernet 0/1
[FirewallB-GigabitEthernet0/1] ipv6 address 3001::2/64
[FirewallB-GigabitEthernet0/1] quit
# Configure an IPv6 static route with destination IP address 2001::/64 and next hop address
3001::1.
[FirewallB] ipv6 route-static 2001:: 64 3001::1
3. Configure the host:
# Enable IPv6 for the host to obtain an IPv6 address automatically through IPv6 ND.
# Execute the ping ipv6 command on Firewall A to verify the connectivity between Firewall A and
Firewall B.
[FirewallA] ping ipv6 3001::1
PING 3001::1 : 56 data bytes, press CTRL_C to break
Reply from 3001::1
bytes=56 Sequence=0 hop limit=64 time = 3 ms
Reply from 3001::1
bytes=56 Sequence=1 hop limit=64 time = 3 ms
Reply from 3001::1
bytes=56 Sequence=2 hop limit=64 time = 3 ms
Reply from 3001::1
bytes=56 Sequence=3 hop limit=64 time = 3 ms
Reply from 3001::1
bytes=56 Sequence=4 hop limit=64 time = 5 ms
--- 3001::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 3/3/5 ms
# Display the neighbor information about GigabitEthernet 0/2 on Firewall A.
[FirewallA] display ipv6 neighbors interface gigabitethernet 0/2
Type: S-Static D-Dynamic
IPv6 Address Link-layer VID Interface State T Age
FE80::215:E9FF:FEA6:7D14 0015-e9a6-7d14 N/A GE0/2 STALE D 1238
2001::15B:E0EA:3524:E791 0015-e9a6-7d14 N/A GE0/2 STALE D 1248
The output shows that the IPv6 global unicast address that the host obtained is
2001::15B:E0EA:3524:E791.