HP VPN Firewall Appliances Network Management Configuration Guide

735
DHCPv6 client configuration examples
IPv6 prefix acquisition configuration example
Network requirements
The DHCPv6 client Firewall uses DHCPv6 to obtain an IPv6 prefix, the DNS server address, domain
name suffix, SIP server address, and domain name of the SIP server.
Configure the client to create an IPv6 prefix based on the obtained prefix and create a DHCPv6 option
group for the obtained configuration parameters.
Figure 380 Network diagram
Configuration procedure
Before you make the following configuration, configure the DHCPv6 server. For information about
DHCPv6 server, see "Configuring the DHCPv6 server."
# Enable IPv6.
<Firewall> system-view
[Firewall] ipv6
# Configure the IP address of GigabitEthernet 0/1.
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] ipv6 address 1::2/48
# Configure GigabitEthernet 0/1 to use DHCPv6 to obtain an IPv6 prefix and configuration parameters,
and enable rapid prefix assignment. With the obtained prefix and parameters, the client automatically
creates a DHCPv6 option group.
[Firewall-GigabitEthernet0/1] ipv6 dhcp client pd 1 rapid-commit option-group 1
[Firewall-GigabitEthernet0/1] quit
Verifying the configuration
# Display DHCPv6 client information. The output shows that Router has obtained an IPv6 prefix and
configuration parameters.
[Firewall] display ipv6 dhcp client
GigabitEthernet0/1:
Type: Stateful client requested for prefix
State: OPEN