HP VPN Firewall Appliances Network Management Configuration Guide

737
Figure 381 Network diagram
Configuration procedure
Before you make the following configuration, configure the DHCPv6 server. For information about
DHCPv6 server, see "Configuring the DHCPv6 server."
# Enable IPv6.
<Firewall> system-view
[Firewall] ipv6
# Configure GigabitEthernet 0/1 to use DHCPv6 to obtain an IPv6 address and configuration
parameters, and enable rapid address assignment. With the obtained address and parameters, the
client automatically creates a DHCPv6 option group.
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] ipv6 address dhcp-alloc rapid-commit option-group 1
[Firewall-GigabitEthernet0/1] quit
Verifying the configuration
# Display DHCPv6 client information. The output shows that Firewall has obtained an IPv6 address and
configuration parameters.
[Firewall] display ipv6 dhcp client
GigabitEthernet0/1:
Type: Stateful client requested for address
State: OPEN
IAID: 0xf0019
Preferred server:
Reachable via address: FE80::200:5EFF:FE0A:2303
DUID: 00030001000fe20a0a00
Address: 1:2::2
Preferred lifetime 60 sec, valid lifetime 60 sec
T1 30 sec, T2 48 sec
Will expire at Jul 18 2011 10:06:57
DNS server addresses:
2000::FF
Domain names:
example.com
SIP server addresses:
2:2::4