HP VPN Firewall Appliances Network Management Configuration Guide

755
To configure an inbound or outbound additional routing metric:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Specify an inbound routing
additional metric.
ripng metricin value
Optional.
0 by default.
4. Specify an outbound
routing additional metric.
ripng metricout value
Optional.
1 by default.
Configuring RIPng route summarization
Ste
p
Command
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Advertise a summary IPv6 prefix.
ripng summary-address ipv6-address prefix-length
Advertising a default route
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
To advertise a default route:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Advertise a default route.
ripng default-route { only | originate } [ cost
cost ]
Not advertised by default.
Configuring a RIPng route filtering policy
You can reference a configured IPv6 ACL or prefix list to filter received or advertised routing information.
You can also specify a routing protocol to filter outbound routes redistributed from the protocol.
To configure a RIPng route filtering policy:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter RIPng view.
ripng [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A