HP VPN Firewall Appliances Network Management Configuration Guide

765
Figure 392 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure RIPng basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] ripng 1
[RouterA-ripng-1] quit
[RouterA] interface gigabitethernet 0/1
[RouterA-GigabitEthernet0/1] ripng 1 enable
[RouterA-GigabitEthernet0/1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ripng 1
[RouterB-ripng-1] quit
[RouterB] interface gigabitethernet 0/1
[RouterB-GigabitEthernet0/1] ripng 1 enable
[RouterB-GigabitEthernet0/1] quit
[RouterB] interface gigabitethernet 0/2
[RouterB-GigabitEthernet0/2] ripng 1 enable
[RouterB-GigabitEthernet0/2] quit
# Configure Firewall.
<Firewall> system-view
[Firewall] ripng 1
[Firewall-ripng-1] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] ripng 1 enable
[Firewall-GigabitEthernet0/1] quit
3. Configure RIPng IPsec policies:
# On Router A, create an IPsec proposal named tran1, and set the encapsulation mode to
transport mode, the security protocol to ESP, the encryption algorithm to DES, and authentication
algorithm to SHA1. Create an IPsec policy named policy001, specify the manual mode for it,
reference IPsec proposal tran1, set the SPIs of the inbound and outbound SAs to 12345, and the
keys for the inbound and outbound SAs using ESP to abcdefg.
[RouterA] ipsec transform-set tran1
[RouterA-ipsec-transform-set-tran1] encapsulation-mode transport
[RouterA-ipsec-transform-set-tran1] transform esp
[RouterA-ipsec-transform-set-tran1] esp encryption-algorithm des
[RouterA-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[RouterA-ipsec-transform-set-tran1] quit
[RouterA] ipsec policy policy001 10 manual