HP VPN Firewall Appliances Network Management Configuration Guide

772
Ste
p
Command Remarks
3. Configure a network
type for the OSPFv3
interface.
ospfv3 network-type { broadcast | nbma
| p2mp [ non-broadcast ] | p2p }
[ instance instance-id ]
Optional.
The network type of an interface
depends on the media type of the
interface.
Configuring an NBMA or P2MP neighbor
For NBMA and P2MP interfaces (only when in unicast mode), you must specify the link-local IP addresses
of their neighbors because these interfaces cannot find neighbors through broadcasting hello packets.
You can also specify DR priorities for neighbors.
To configure an NBMA or P2MP (unicast) neighbor and its DR priority:
Ste
p
Command
1. Enter system view.
system-view
2. Enter interface view.
interface interface-type interface-number
3. Specify an NBMA or P2MP (unicast)
neighbor and its DR priority.
ospfv3 peer ipv6-address [ dr-priority dr-priority ] [ instance
instance-id ]
Configuring OSPFv3 routing information control
This section describes how to configure the control of OSPFv3 routing information advertisement and
reception, and redistribution from other protocols.
Configuration prerequisites
Before you configure OSPFv3 routing information control, complete the following tasks:
• Enable IPv6 packet forwarding.
• Configure OSPFv3 basic functions.
Configuring OSPFv3 route summarization
If contiguous network segments exist in an area, you can use the abr-summary command to summarize
them into one network segment on the ABR. The ABR will advertise only the summary route. Any LSA on
the specified network segment will not be advertised, reducing the LSDB size in other areas.
To configure route summarization:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Enter OSPFv3 area view.
area area-id N/A