HP VPN Firewall Appliances Network Management Configuration Guide

774
To configure a bandwidth reference value:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
Optional.
100 Mbps by default.
Configuring the maximum number of OSPFv3 ECMP routes
Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Specify the maximum
number of ECMP routes.
maximum load-balancing
maximum
Optional.
By default, the maximum number is 8.
Configuring a priority for OSPFv3
A router can run multiple routing protocols. The system assigns a priority to each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is selected.
To configure a priority for OSPFv3:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter OSPFv3 view.
ospfv3 [ process-id ] N/A
3. Configure a priority for
OSPFv3.
preference [ ase ]
[ route-policy
route-policy-name ]
preference
Optional.
By default, the priority of OSPFv3 internal routes is 10,
and the priority of OSPFv3 external routes is 150.
Configuring OSPFv3 route redistribution
When you configure OSPFv3 route redistribution, follow these guidelines:
• Executing the import-route or default-route-advertise command on a router makes it become an
ASBR.
• You can only inject and advertise a default route by using the default-route-advertise command.
• Because OSPFv3 is a link state routing protocol, it cannot directly filter LSAs to be advertised; you
must filter redistributed routes first. Routes that are not filtered out can be advertised in LSAs.