HP VPN Firewall Appliances Network Management Configuration Guide

781
Task Command Remarks
Display OSPFv3 statistics.
display ospfv3 statistics [ | { begin | exclude | include }
regular-expression ]
Available in
any view.
OSPFv3 configuration examples
Configuring OSPFv3 areas
Network requirements
In Figure 393, all devices run OSPFv3. The AS is split into three areas, in which, Router B and Router C
act as ABRs to forward routing information between areas.
Configure Area 2 as a stub area in order to reduce LSAs in the area without affecting route reachability.
Figure 393 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure OSPFv3 basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] ipv6
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface gigabitethernet 0/1
[RouterA-GigabitEthernet0/1] ospfv3 1 area 1
[RouterA-GigabitEthernet0/1] quit
[RouterA] interface gigabitethernet 0/2
[RouterA-GigabitEthernet0/2] ospfv3 1 area 1
[RouterA-GigabitEthernet0/2] quit
# Configure Router B.
<RouterB> system-view
[RouterB] ipv6
[RouterB] ospfv3 1