HP VPN Firewall Appliances Network Management Configuration Guide
784
------------------------------------------------------------------------
*Destination: ::/0
Type : IA Cost : 11
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
*Destination: 2001::/64
Type : IA Cost : 2
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
*Destination: 2001:1::/64
Type : IA Cost : 3
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
*Destination: 2001:2::/64
Type : I Cost : 1
NextHop : directly-connected Interface: GE0/2
*Destination: 2001:3::/64
Type : IA Cost : 4
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
4. Configure Area 2 as a totally stub area to reduce the stub area routing table size:
# Configure Area 2 as a totally stub area on Router C.
[RouterC-ospfv3-1-area-0.0.0.2] stub no-summary
# Display OSPFv3 routing table information on Firewall.
[Firewall] display ospfv3 routing
E1 - Type 1 external route, IA - Inter area route, I - Intra area route
E2 - Type 2 external route, * - Selected route
OSPFv3 Router with ID (4.4.4.4) (Process 1)
------------------------------------------------------------------------
*Destination: ::/0
Type : IA Cost : 11
NextHop : FE80::F40D:0:93D0:1 Interface: GE0/2
*Destination: 2001:2::/64
Type : I Cost : 1
NextHop : directly-connected Interface: GE0/2
The output shows that route entries are reduced. All non-direct routes are removed, except the
default route.
Configuring OSPFv3 DR election
Network requirements
• In Figure 394, the priority of Firewall is 100, the highest priority on the network, so it becomes the
DR.
• The priority of Router C is 2, the second highest priority on the network, so it becomes the BDR.