HP VPN Firewall Appliances Network Management Configuration Guide

800
• Enable IPv6 globally.
• Configure IP addresses for interfaces, and make sure that all neighboring nodes can reach each
other.
• Enable IS-IS.
Configuration procedure
To configure basic IS-IS:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enable an IS-IS process and enter IS-IS
view.
isis [ process-id ] Not enabled by default.
3. Configure the network entity title for
the IS-IS process.
network-entity net Not configured by default.
4. Enable IPv6 for the IS-IS process.
ipv6 enable Disabled by default.
5. Return to system view.
quit N/A
6. Enter interface view.
interface interface-type
interface-number
N/A
7. Enable IPv6 for an IS-IS process on the
interface.
isis ipv6 enable [ process-id ] Disabled by default.
Configuring IPv6 IS-IS route control
Before you configure IPv6 IS-IS route control, complete basic IPv6 IS-IS configuration.
For information about ACL, see ACL and QoS Configuration Guide.
For information about routing policy and IPv6 prefix list, see "Configuring routing policies."
To configure IPv6 IS-IS route control:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] N/A
3. Specify the preference
for IPv6 IS-IS routes.
ipv6 preference { route-policy
route-policy-name | preference } *
Optional.
15 by default.
4. Configure an IPv6 IS-IS
summary route.
ipv6 summary ipv6-prefix prefix-length
[ avoid-feedback | generate_null0_route |
[ level-1 | level-1-2 | level-2 ] | tag tag ] *
Optional.
Not configured by default.
5. Generate an IPv6 IS-IS
default route.
ipv6 default-route-advertise [ [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name ] *
Optional.
No IPv6 default route is
defined by default.