HP VPN Firewall Appliances Network Management Configuration Guide

808
Task Remarks
Configuring inbound route filtering Optional
Configuring IPv6 BGP and IGP route synchronization Optional
Configuring route dampening Optional
Configuring IPv6
BGP route
attributes
Configuring IPv6 BGP preference and default LOCAL_PREF and
NEXT_HOP attributes
Optional
Configuring the MED attribute Optional
Configuring the AS_PATH attribute Optional
Tuning and
optimizing IPv6
BGP networks
Configuring IPv6 BGP timers Optional
Configuring IPv6 BGP soft reset Optional
Enabling the IPv6 BGP ORF capability Optional
Enabling 4-byte AS number suppression Optional
Configuring the maximum number of ECMP routes Optional
Enabling MD5 authentication for TCP connections Optional
Applying an IPsec policy to an IPv6 BGP peer or peer group Optional
Configuring a
large-scale IPv6
BGP network
Configuring IPv6 BGP peer group Optional
Configuring IPv6 BGP community Optional
Configuring an IPv6 BGP route reflector Optional
Configuring BFD for IPv6 BGP Optional
Configuring IPv6 BGP basic functions
Configuration prerequisites
Before you configure IPv6 BGP basic functions, complete the following tasks:
• Specify IP addresses for interfaces.
• Enable IPv6 with the ipv6 command in system view.
• Create a peer group before configuring basic functions for it. For related information, see
"Configuring IPv6 BGP peer group."
Specifying an IPv6 BGP peer
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Specify a router ID.
router-id router-id
Optional.
Required, if no IP addresses are
configured for any interfaces.