HP VPN Firewall Appliances Network Management Configuration Guide

820
To enable the BGP ORF capability:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Enable BGP route refresh for a
peer or peer group.
peer { group-name | ipv6-address }
capability-advertise route-refresh
Enabled by default.
5. Enable the non-standard ORF
capability for a BGP peer or
peer group.
peer { group-name | ipv6-address }
capability-advertise orf non-standard
Optional.
By default, standard BGP
ORF capability defined in
RFC 5291 and RFC 5292 is
supported.
6. Enable the ORF IP prefix
negotiation capability for a
BGP peer or peer group.
peer { group-name | ip-address |
ipv6-address } capability-advertise orf
ipv6-prefix { both | receive | send }
Not supported by default.
Table 78 Description of the both, send, and receive parameters and the negotiation result
Local
p
arameter Peer
p
arameter Ne
g
otiation result
send
• receive
• both
The ORF sending capability is enabled locally and the
ORF receiving capability is enabled on the peer.
receive
• send
• both
The ORF receiving capability is enabled locally and the
ORF sending capability is enabled on the peer.
both both
Both the ORF sending and receiving capabilities are
enabled locally and on the peer.
Enabling 4-byte AS number suppression
When a device that supports 4-byte AS numbers sends an Open message for peer relationship
establishment, the Optional parameters field of the message indicates that the AS number occupies four
bytes—in the range of 1 to 4294967295. If the peer device does not support 4-byte AS numbers (for
examples, it supports only 2-byte AS numbers), the peer relationship cannot be established.
After you enable the 4-byte AS number suppression function, the peer device can then process the Open
message even though it does not support 4-byte AS numbers, and the IPv6 BGP peer relationship can be
established.
If the peer device supports 4-byte AS numbers, do not enable the 4-byte AS number suppression function.
Otherwise, the BGP peer relationship cannot be established.
To enable 4-byte AS number suppression:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A