HP VPN Firewall Appliances Network Management Configuration Guide

823
Configuring IPv6 BGP peer group
Configuring an IBGP peer group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A
4. Create an IBGP peer group.
group ipv6-group-name [ internal ] N/A
5. Add a peer into the group.
peer ipv6-address group ipv6-group-name
[ as-number as-number ]
Not added by
default.
Creating a pure EBGP peer group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A
4. Create an EBGP peer group.
group ipv6-group-name external N/A
5. Configure the AS number for the
peer group.
peer ipv6-group-name as-number
as-number
Not configured by
default.
6. Add an IPv6 peer into the peer
group.
peer ipv6-address group ipv6-group-name
Not added by
default.
NOTE:
• To create a pure EBGP peer group, you must specify an AS number for the peer group.
• If a peer was added into an EBGP peer
g
roup, you cannot specify any AS number for the peer
g
roup.
Creating a mixed EBGP peer group
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 address family view.
ipv6-family N/A
4. Create an EBGP peer group.
group ipv6-group-name external N/A
5. Specify the AS number of an
IPv6 peer.
peer ipv6-address as-number as-number
Not specified by default.
6. Add the IPv6 peer into the peer
group.
peer ipv6-address group
ipv6-group-name
Not added by default.