HP VPN Firewall Appliances Network Management Configuration Guide

846
To configure IPv6 interface PBR:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Apply an IPv6 policy on the
interface.
ipv6 policy-based-route
policy-name
Not applied by default.
Displaying and maintaining IPv6 PBR configuration
Task Command Remarks
Display information about IPv6
local PBR and IPv6 interface PBR.
display ipv6 policy-based-route [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display IPv6 PBR configuration.
display ipv6 policy-based-route setup
{ policy-name | interface interface-type
interface-number | local } [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display IPv6 PBR statistics.
display ipv6 policy-based-route statistics
{ interface interface-type interface-number |
local } [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display IPv6 PBR policy.
display ipv6 config policy-based-route
[ policy-name ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Clear IPv6 PBR statistics. reset ipv6 policy-based-route statistics Available in user view.
IPv6 PBR configuration examples
Configuring IPv6 local PBR based on packet type
Network requirements
As shown in Figure 403, configure IPv6 local PBR on Firewall to forward all locally generated TCP
packets through GigabitEthernet 0/1. Router A forwards other IPv6 packets according to the routing
table.
Figure 403 Network diagram