HP VPN Firewall Appliances Network Management Configuration Guide

859
[RouterA-Ethernet1/2] quit
[RouterA] interface tunnel 0
[RouterA-Tunnel0] pim ipv6 dm
[RouterA-Tunnel0] quit
# On the firewall, enable IPv6 multicast routing globally, enable MLD on GigabitEthernet 0/1,
and enable IPv6 PIM-DM on each interface.
[Firewall] multicast ipv6 routing-enable
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] mld enable
[Firewall-GigabitEthernet0/1] pim ipv6 dm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/2
[Firewall-GigabitEthernet0/2] pim ipv6 dm
[Firewall-GigabitEthernet0/2] quit
[Firewall] interface tunnel 0
[Firewall-Tunnel0] pim ipv6 dm
[Firewall-Tunnel0] quit
Verifying the configuration
The source sends the IPv6 multicast data to the IPv6 multicast group FF1E::101 and the receiver can
receive the IPv6 multicast data after joining the IPv6 multicast group. You can use the display pim ipv6
routing-table command to display IPv6 PIM routing table information on routers . For example:
# Display IPv6 PIM routing table information on the firewall.
[Firewall] display pim ipv6 routing-table
Total 1 (*, G) entry; 1 (S, G) entry
(*,FF1E::101)
Protocol: pim-dm, Flag: WC
UpTime: 00:04:25
Upstream interface: NULL
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet0/1
Protocol: igmp, UpTime: 00:04:25, Expires: never
(1001::100, FF1E::101)
Protocol: pim-dm, Flag: ACT
UpTime: 00:06:14
Upstream interface: Tunnel0
Upstream neighbor: 5001::1
RPF prime neighbor: 5001::1
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet0/1
Protocol: pim-dm, UpTime: 00:04:25, Expires: never