HP VPN Firewall Appliances Network Management Configuration Guide

891
Device Interface IPv6 address Device Interface IPv6 address
Router B S2/2 3003::1/64 Router E Eth1/1 2003::2/64
Router B POS5/1 2002::2/64 Router F Eth1/1 9001::1/64
Router B POS5/2 3004::1/64 Router F S2/1 8001::2/64
Router G S2/1 4001::1/64 Source 1 — 2001::100/64
Router G POS5/1 3004::2/64 Source 2 — 3001::100/64
Router H Eth1/1 5001::1/64 Source 3 — 9001::100/64
Router H S2/1 4001::2/64
Configuration procedure
1. Assign IPv6 addresses and configure unicast routing:
a. Assign an IPv6 address and prefix length to each interface according to Figure 409. (Details
not shown.)
b. Configure OSPFv3 on the routers in the IPv6 PIM-SM domain to make su
re they are
interoperable at the network layer. (Details not shown.)
2. Enable IPv6 multicast routing and IPv6 administrative scoping, MLD and IPv6 PIM-SM:
# On Router A, enable IPv6 multicast routing and IPv6 administrative scoping, enable MLD on the
host-side interface Ethernet 1/1, and enable IPv6 PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] pim ipv6
[RouterA-pim6] c-bsr admin-scope
[RouterA-pim6] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 sm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim ipv6 sm
[RouterA-Ethernet1/2] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, MLD and IPv6 PIM-SM on Router
B and Router H in the same way. (Details not shown.)
# On the firewall, enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6
PIM-SM on each interface.
<Firewall> system-view
[Firewall] multicast ipv6 routing-enable
[Firewall] pim ipv6
[Firewall-pim6] c-bsr admin-scope
[Firewall-pim6] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] pim ipv6 sm
[Firewall-GigabitEthernet0/1] quit
[Firewall] interface gigabitethernet 0/1
[Firewall-GigabitEthernet0/1] pim ipv6 sm