HP VPN Firewall Appliances Network Management Configuration Guide

ManualsBrandsHP ManualsComputer AccessoriesHP ProCurve Switch xl Access Controller Module

911

912

913

914

915

916

917

918

919

920

892

[Firewall-GigabitEthernet0/1] quit

[Firewall] interface gigabitethernet 0/2

[Firewall-GigabitEthernet0/2] pim ipv6 sm

[Firewall-GigabitEthernet0/2] quit

[Firewall] interface gigabitethernet 0/3

[Firewall-GigabitEthernet0/3] pim ipv6 sm

[Firewall-GigabitEthernet0/3] quit

# Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM on

Router B, Router C, Router E, Router F, and Router G in the same way. (Details not shown.)

3. Configure an IPv6 admin-scoped zone boundary:

# On the firewall, configure GigabitEthernet 0/3 and GigabitEthernet 0/4 as the boundary of

IPv6 admin-scoped zone 1.

[Firewall] interface gigabitethernet 0/3

[Firewall-GigabitEthernet0/3] multicast ipv6 boundary scope 4

[Firewall-GigabitEthernet0/3] quit

[Firewall] interface gigabitethernet 0/4

[Firewall-GigabitEthernet0/4] multicast ipv6 boundary scope 4

[Firewall-GigabitEthernet0/4] quit

# On Router B, configure Ethernet 1/2 and POS 5/2 as the boundary of IPv6 admin-scoped zone

<RouterB> system-view

[RouterB] interface ethernet 1/2

[RouterB-Ethernet1/2] multicast ipv6 boundary scope 4

[RouterB-Ethernet1/2] quit

[RouterB] interface pos 5/2

[RouterB-Pos5/2] multicast ipv6 boundary scope 4

[RouterB-Pos5/2] quit

# On Router C, configure POS 5/1 as the boundary of admin-scoped zone 2.

<RouterC> system-view

[RouterC] interface pos 5/1

[RouterC-Pos5/1] multicast ipv6 boundary scope 4

[RouterC-Pos5/1] quit

4. Configure C-BSRs and C-RPs:

# On the firewall, configure the service scope of RP advertisements and configure GigabitEthernet

0/2 as a C-BSR and C-RP of admin-scoped zone 1.

[Firewall] pim ipv6

[Firewall-pim6] c-bsr scope 4

[Firewall-pim6] c-bsr 1002::2

[Firewall-pim6] c-rp 1002::2 scope 4

[Firewall-pim6] quit

# On Router C, configure the service scope of RP advertisements and configure Serial 2/1 as a

C-BSR and C-RP of admin-scoped zone 2.

[RouterC] pim ipv6

[RouterC-pim6] c-bsr scope 4

[RouterC-pim6] c-bsr 3002::2

[RouterC-pim6] c-rp 3002::2 scope 4

[RouterC-pim6] quit