HP VPN Firewall Appliances Network Management Configuration Guide

919
Figure 411 Network diagram
Configuration procedure
1. Enable IPv6 forwarding, assign IPv6 addresses, and configure IPv6 unicast routing:
a. Enable IPv6 forwarding on each router and assign an IPv6 address and prefix length to each
interface according to Figure 411. (Details not shown.)
b. Configure OSPFv3 on the routers to make sure they are interoperable at the network layer and
they can dynamically upd
ate their routing information. (Details not shown.)
2. Enable the IPv6 multicast routing, MLD, and IPv6 PIM-DM:
# On Firewall A, enable IPv6 multicast routing globally, enable MLD on the host-side interface
GigabitEthernet 0/1, and enable IPv6 PIM-DM on each interface.
<FirewallA> system-view
[FirewallA] multicast ipv6 routing-enable
[FirewallA] interface gigabitethernet 0/1
[FirewallA-GigabitEthernet0/1] mld enable
[FirewallA-GigabitEthernet0/1] pim ipv6 dm
[FirewallA-GigabitEthernet0/1] quit
[FirewallA] interface gigabitethernet 0/2
[FirewallA-GigabitEthernet0/2] pim ipv6 dm
[FirewallA-GigabitEthernet0/2] quit
# On Firewall B, enable IPv6 multicast routing globally, enable MLD on the host-side interface
GigabitEthernet 0/1, and enable IPv6 PIM-DM on each interface.
<FirewallB> system-view
[FirewallB] multicast ipv6 routing-enable
[FirewallB] interface gigabitethernet 0/1
[FirewallB-GigabitEthernet0/1] mld enable
[FirewallB-GigabitEthernet0/1] pim ipv6 dm
[FirewallB-GigabitEthernet0/1] quit
[FirewallB] interface gigabitethernet 0/2
Firewall A
Firewall B
Querier
IPv6 PIM network
N1
N2
Receiver
Receiver
Host A
Host B
Host C
Host D
GE0/1
3000::12/64
GE0/1
3001::10/64
GE0/2
GE0/2