HP VPN Firewall Appliances VPN Command Reference

114
Views
L2TP group view
Default command level
2: System level
Usage guidelines
When you start a PPP session, a client of NAS-initialized VPN will first negotiate with the NAS for LCP
parameters. If the negotiation succeeds, the NAS initializes a tunnel and then transfers the negotiated
results to the LNS. Then the LNS verifies whether the client is valid, depending on the proxy authentication
information. You can use the mandatory-lcp command to force the LNS to perform LCP re-negotiation for
the client. In this case, the proxy authentication information of the NAS will be neglected. Some PPP
clients might not support LCP re-negotiation. In this case, the LCP re-negotiation will fail.
Examples
# Perform LCP negotiation by force.
<Sysname> system-view
[Sysname] l2tp-group 1
[Sysname-l2tp1] mandatory-lcp
Related commands
mandatory-chap
reset l2tp tunnel
Use reset l2tp tunnel to disconnect tunnels and all sessions of the tunnels.
Syntax
reset l2tp tunnel { id tunnel-id | name remote-name }
Views
User view
Default command level
2: System level
Parameters
id tunnel-id: Specifies a tunnel by its local ID.
The following matrix shows the value range for the tunnel-id argument on different firewalls and firewall
modules:
Hardware Value ran
g
e
F1000-A-EI/F1000-S-EI 1 to 8192
F1000-E 1 to 8192
F5000 1 to 8192
F5000-S/F5000-C 1 to 8192
VPN firewall modules 1 to 8192
20-Gbps VPN firewall modules 1 to 1024