HP VPN Firewall Appliances VPN Command Reference

80
Syntax
ipsec policy policy-name seq-number [ isakmp | manual ]
undo ipsec policy policy-name [ seq-number ]
Default
No IPsec policy exists.
Views
System view
Default command level
2: System level
Parameters
policy-name: Specifies the name for the IPsec policy, a case-insensitive string of 1 to 15 characters. No
hyphen (-) can be included.
seq-number: Specifies the sequence number for the IPsec policy, in the range of 1 to 65535.
isakmp: Sets up SAs through IKE negotiation.
manual: Sets up SAs manually.
Usage guidelines
When creating an IPsec policy, you must specify the generation mode.
You cannot change the generation mode of an existing IPsec policy; you can only delete the policy and
then re-create it with the new mode.
IPsec policies with the same name constitute an IPsec policy group. An IPsec policy is identified uniquely
by its name and sequence number. In an IPsec policy group, an IPsec policy with a smaller sequence
number has a higher priority.
The undo ipsec policy command without the seq-number argument deletes an IPsec policy group.
Examples
# Create an IPsec policy with the name policy1 and sequence number 100, and specify to set up SAs
through IKE negotiation.
<Sysname> system-view
[Sysname] ipsec policy policy1 100 isakmp
[Sysname-ipsec-policy-isakmp-policy1-100]
# Create an IPsec policy with the name policy1 and specify the manual mode for it.
<Sysname> system-view
[Sysname] ipsec policy policy1 101 manual
[Sysname-ipsec-policy-manual-policy1-101]
Related commands
• ipsec policy (interface view)
• display ipsec policy