TMS zl Module Release Notes ST.1.0.090213
9
Known Issues
Release ST.1.0.090213
2. Add a second syslog server using the same IP address
ProCurve Switch(tms-module-D:config)# logging syslog 192.168.1.59 514 facility
local2
3. Delete the syslog server
ProCurve Switch(tms-module-D:config)# no logging syslog 192.168.1.59
The first syslog server is deleted and there is no way to specify the second syslog server except
to execute the no logging syslog 192.168.1.59 command again.
■ PR_0000005390 — The administrator cannot change the password for MD5 authentication
on an OSPF interface without knowing the previous password. As a workaround, first disable
the VLAN from OSPF and then re-enable it with the new password.
■ PR_0000006127/ PR_0000016218 — The output of the show run command will show an
FDPoll Returned Error message, which is not relevant to the output and
inconsequential. It can safely be ignored.
■ PR_0000007300/PR_0000007303 — From the CLI, the logging command does not
auto-complete when the Tab key is pressed as other commands from the command line do.
As a result, the user must fully type the parameter needed.
For example, the following commands do not auto-complete to enable when the Tab key is
pressed after only en is typed:
ProCurve Switch(tms-module-D:config)# logging syslog en
ProCurve Switch(tms-module-D:config)# logging snmpv2 en
ProCurve Switch(tms-module-D:config)# logging snmpv3 en
■ PR_0000007394 — A vague message is displayed when the maximum number of users have
already been added to a group and an administrator attempts to add another user to the
group.
CLI:
Error: Failed to add user group: 88
Web browser interface: The user could not be added.
■ PR_0000007723 — In the TMS zl Module CLI, an error message should be displayed and
the entry rejected when an invalid mask value is used for IP Address/Mask when specifying
an IP address for a VLAN. The user must carefully validate their input.
In the following example the incorrect mask value may result in the wrong subnet mask being
used:
ProCurve Switch(tms-module-D:config)# vlan 1 ip address 192.168.11.25/2254
Success: Set VLAN 1 IP address to: 192.168.11.25 255.255.252.0
■ PR_0000007740 — During a UDP flood, the log incorrectly refers to it as a TCP flood by
using
tcpconnectionanomaly. As a result, the administrator will not know whether a UDP
flood is occurring or a TCP flood is occurring.